Yamaha YZ125 2019 Owner's Service Manual page 192

INSTALLING THE HANDLEBAR
1. Install:
• Lower handlebar holder "1"
• Washer "2"
• Nut (lower handlebar holder) "3"
• Install the lower handlebar holders with them
side having the greater distance "a" from the
mounting bolt center facing forward.
• Apply the lithium soap base grease on the
thread of the lower handlebar holders.
• Installing the lower handlebar holders in the
reverse direction allow the front-to-rear offset
amount of the handlebar position to be
changed.
• Do not tighten the nuts yet.
2. Install:
• Handlebar "1"
• Upper handlebar holder "2"
• Bolt (upper handlebar holder) "3"
Bolt (upper handlebar holder):
28 Nm (2.8 m•kg, 20 ft•lb)
• The upper handlebar holders should be in-
stalled with the punch marks "a" facing for-
ward.
• Install the handlebar so that the marks "b" are
in place on both sides.
• Install the handlebar so that the projection "c"
of the upper handlebar holders is positioned
at the mark on the handlebar as shown.
• First tighten the bolts on the front side of the
upper handlebar holder, and then tighten the
bolts on the rear side.
5-39
HANDLEBAR