Yamaha YZ125 2019 Owner's Service Manual page 193

3. Tighten:
• Nut (lower handlebar holder) "1"
Nut (lower handlebar holder):
40 Nm (4.0 m•kg, 29 ft•lb)
4. Install:
• Left grip "1"
Apply the adhesive to the handlebar "2".
• Before applying the adhesive, wipe off grease
or oil on the handlebar surface "a" with a lac-
quer thinner.
• Install the left grip to the handlebar so that the
line "b" between the two arrow marks faces
straight upward.
5. Install:
• Collar "1"
• Grip cap cover "2"
• Throttle grip "3"
• Apply the lithium soap base grease on the
throttle grip sliding surface.
• Tighten the grip cap bolts temporarily without
the throttle being fixed to the handlebar.
6. Install:
• Throttle cables "1"
To tube guide "2".
Apply the lithium soap base grease on the
throttle cable end and tube guide cable winding
portion.
7. Install:
• Roller "1"
• Collar "2"
• Apply the lithium soap base grease on the
roller sliding surface and cable guide.
• Install the roller so that the "UPPER" mark "a"
faces upward.
• Pass the throttle cable in the groove "b" in the
roller.
5-40
HANDLEBAR