Table of Contents
Advertisement
Properties button. Click the Driver tab and click the Update Driver button. When
the Hardware Update Wizard appears, select Install from a list or specific
location (Advanced) and click Next. Select Don't search. I will choose the driver
to install. Click Next. Click Have Disk. Insert the Installation CD-ROM into your
CD-ROM drive, type the letter of your CD-ROM drive, and click OK. Click to select
U.S. Robotics Courier V.Everything EXT PnP. Click Next. A Hardware Installation
warning may appear. Click Continue Anyway if it does*. Click Finish to complete
the installation.
All Other Operating Systems
Beyond full support of the Windows Operating Systems described in this
manual, the Courier 56K Corporate Modem will function in any operating system
that supports an RS-232 COM port, such as DOS, Linux, or UNIX. Standard COM
port settings are: bits per second: 115,200; data bits: 8; parity: none; stop bits:
1; flow control: hardware. Assign your terminal application to utilize the COM
port to which you connect the modem's serial cable. Additional setup
information can be found in the 3453 FAQ section at http://www.usr.com/
support
*U.S. Robotics has thoroughly tested this driver in conjunction with the supported hardware and has
verified compatibility with Windows XP and 2000.
Register your modem.
At the Installation CD-ROM interface, click the Support link.
•
•
Follow the on-screen instructions to register your modem and to view
the warranty information. Click Windows Start and then click Run. In
the "Run" dialogue box, type D:\setup.exe. If your CD-ROM drive uses
a different letter, type that letter in place of "D".
Configuring V.Everything
NOTE:
computer before the country setting can be changed.
Start a terminal program (e.g., Hyperterminal). Follow these three steps:
1.
Type the AT command AT~C? and then press ENTER. A screen displaying
the list of countries supported by the modem appears as shown in the fol-
lowing list.
2.
Select the country in which you plan to operate the modem and enter the
AT command ATC10=XX. For example, to set the country of operation to
8
The modem needs to be installed and communicating with the
Advertisement
Table of Contents
