Panel Facilities - Pioneer A-402 Operating Instructions Manual

PANEL FACILITIES
[FRONT PANEL]
The illustration shows model A-402.
Model A-302 is not equipped with @ and @.
@ POWER switch/indicator
Press to turn power to the unit on and off.
When the power is on, the indicator lights.
@ ACTIVE TONE CONTROL
Ordinarily, the more the volume control is turned down, the more
obvious the loudness characteristics become. Since the effects of
this unit's tone control settings are increasingly emphasized as the
volume is turned down, you can obtain the same kind of effect as
loudness characteristics by using suitable tone control settings.
TREBLE tone control
Use to adjust the high-frequency tone at low volume level. The
center position is the flat (normal) position. When turned to the right,
high-frequency tones are emphasized; when turned to the left, high-
frequency tones are de-emphasized.
NOTE:
© This control does not operate when DIRECT switch is in the on
position.
® At volume levels below the 10 o'clock position, the set tone control
effect is obtained.
At volume levels above the 10 o'clock position, the effect becomes
increasingly weaker.
BASS tone control
Use to adjust the low-frequency tone atlow volume level. The center
position is the flat (normal) position. When turned to the right, low-
frequency tones are emphasized; when turned to the left, low-
frequency tones are de-emphasized.
NOTE:
¢ This control does not operate when DIRECT switch is in the on
position.
@ At volume levels below the 10 o'clock position, the set tone control
effect is obtained.
At volume levels above the 10 o'clock position, the effect becomes
increasingly weaker.
@ REC SELECTOR switch
When this switch is set to a position other than SOURCE or OFF, the
equipment selected by REC SELECTOR switch can be recorded
from, irrespective of the settings of INPUT SELECTOR and DIRECT
switches.
TUNER:
To record from the equipment connected to TUNER terminals.
CD:
To record from the equipment connected to CD terminals.
OFF:
In this position, nothing from REC terminals of TAPE 1/DAT and TAPE 2
is output. Set to this position when not recording; the cassette deck will
be disconnected, improving sound quality.
SOURCE:
To record from the equipment selected by INPUT SELECTOR switch.
TAPE:
1 2:
To record (copy) from the cassette deck of TAPE 1/DAT terminals, to
the cassette deck of TAPE 2 terminals.
2h 1:
To record (copy) from the cassette deck of TAPE 2 terminals, to the
cassette deck of TAPE 1/DAT terminals.
3
<ARB1433>