Table of Contents
Advertisement
6. PANEL FACILITIES
yA ow A 2)
vm Z
@ POWER switch/indicator
Press to turn power to the unit ON and OFF.
When the power is ON, the indicator lights.
@ PHONES jack
When using headphones, insert the plug into this jack.
@ SPEAKERS selector switch
Use
this
switch
to listen
to the
speaker
systems
connected
to
SPEAKERS terminals.
OFF:
Released position: No sound is heard from the speaker systems. Set
to this position when listening with headphones.
A:
For reproduction of sound with the speaker system connected to the
SPEAKERS A terminals.
.
B:
For reproduction of sound with the speaker system connected to the
SPEAKERS B terminals.
A+B:
For reproduction of sound with the speaker systems connected to
SPEAKERS A and B terminals.
@BASS tone control
Use to adjust the low-frequency tone at low volume level. The center
position is the flat (normal) position. When turned to the right, low-
frequency tones are emphasized; when turned to the left, low-frequency
tones are de-emphasized.
NOTE:
* This function does not operate when the DIRECT button is in the ON.
position.
* At volume levels lower than ''32," the set tone control effect is
obtained.
* At volume levels higher than "32," the effect becomes increasingly
weaker.
@®TREBLE tone control
Use to adjust the high-frequency tone at low volume level. The center
position is the flat (normal) position. When turned to the right, high-
frequency tones are emphasized; when turned to the left, high-
frequency tones are de-emphasized.
NOTE:
* This function does not operate when the DIRECT button is in the ON
position.
© At volume levels lower than "32," the set tone control effect is
obtained.
'* At volume levels higher than "32," the effect becomes increasingly
weaker.
®BALANCE control
'Should normally be left in the center position. Adjust balance if the sound
is louder from one of the speakers. If the right side is louder, turn toward
the LEFT position and if the left side is louder, turn toward the RIGHT
position.
NOTE:
This function does not operate when the DIRECT button is in the ON
position.
31
Advertisement
Table of Contents
