Table of Contents
Advertisement
PANEL FACILITIES
| REAR PANEL
@ MIC INPUT jacks (MIC 1-3)
The MIC INPUT jacks are also used for connection to the
optional wireless mic receiver.
When using microphones with key control remote switch
connected to MIC 1 and 2, connect the contro! cords to
the KEY CONT jacks.
If a microphone is connected to the MIC jack on the front
panel, front input has priority.
NOTES:
® Position of the key controller may change by connecting/dis-
connecting of the remote plug. In such a case, set it again to
the desired position.
® For the key contro! function, both front and rear inputs are
effective.
@ AUDIO LEVEL controls
Lb2
Controls the volume of the LD2 AUDIO INPUT terminals
sound.
Under normal conditions, leave this dial in the center
position.
If you notice excessive difference in sound volume with
the component connected to the KSS/LD1 jacks, use this
dial to adjust the volume.
VCR/TAPE
Control the input sound level of devices connected to
the VCR/TAPE AUDIO INPUT terminals.
Under normal conditions, leave this dial in the center
position.
\f you notice excessive difference in sound volume with
the component connected to the KSS/LD1 jacks, use this
dial to adjust the volume.
CABLE
Controls the volume of the CABLE AUDIO INPUT termi-
nals sound.
Under normal conditions, leave this dial in the center
position.
If you notice excessive difference in sound volume with
the component connected to the KSS/LD1 jacks, use this
dial to adjust the volume.
6
<BRA1107>
En
==
=!
eSem
=>
@ AUDIO OUTPUT jack (MONO)
The L and R audio signals input to the AUDIO
INPUT
jacks (KSS/LD1,LD2,VCR/TAPE,CABLE) always appear as
L +R monaural.
@ AUDIO OUTPUT jacks (R,L)
These jacks are used to output the L and R audio signals
which have been input to the AUDIO INPUT terminals
(KSS/LD1,LD2,VCR/TAPE,CABLE)
of this unit. The sound
from the AUDIO OUTPUT jacks can be adjusted using
the unit's MAIN VOLUME and BALANCE control.
@REMOTE CONTROL input jack
Connect the optional remote control satellite. Installing
the satellite on the ceiling or wail allows the remote con-
trol unit to function properly even if obstacles exist be-
tween the amplifier and the remote control unit. See the
instruction manual of the remote control satellite for
details of connection.
®KSS REQUESTER CONTROL jack
Connect the optional song request system (KSS-V100).
When the remote control unit furnished with the KSS-
V100 is pointed at this amplifier's sensor, the remote
control unit can be used to send data to the connected
song request system.
@® SPEAKERS terminals
For details, refer to "CONNECTIONS" on pages 3, 4.
NOTE:
Always connect the plus (+) and minus (—) wires of the speak-
ers to the speaker terminals of the same polarity. A polarity
error can cause unnatural sound.
@® AUDIO INPUT jacks
KSS/LD1, LD2
Connect to the AUDIO jacks of a LD player.
VCR/TAPE
Connect to the AUDIO OUT jacks of a VCR or to the PLAY
({OQUTPUT) jacks of a cassettedeck.
CABLE
Use to connect a cable broadcast receiver.
Advertisement
Table of Contents
