Table of Contents
Advertisement
CONTENTS
FEATURES seep actarcntee niente
eedaccicanceeataeeies 2
INSTALLATION scccrssieunsensewnst daviveldeivkicaeniatnceors 2
PANEL, PACILITIES .iicunineydsndsinsany, anwesriadaueetieccss 3
CONNECTIONS sce2ticsnitskssgsespseedanpaandcsaaeeauswees 6
OPERATIONS sigeaceinasasendteeiantienetanncnendtste
a neaeanas 8
REMOTE CONTROL: cusicescceucparaier
ee uit
9
TROUBLESHOOTING 1.00... cceceeeeeeee
eee teeeeteeaeneenes 11
SPECIFICATIONS ieee sxe sve taneneuneoaten
ernie aeterines 12
FEATURES
m Remote control integrated amplifier
Convenience
is combined
with
no-compromise
performance.
The remote provides access to ail Pioneer audio equipment with the
mark.
Power output of 45 + 45 watts at 4 ohms, DIN
(30 watts per channel, at 8 ohms from 20 Hz to
20,000 Hz with 0.07 % total harmonic distortion.
_Low-impedance driving capability: To capably drive
speaker with low impedance for better digital sound.
"DIRECT"
button:
For bypassing
the tone
and
balance-control circuits — highest purity results.
m Active tone control: Lows and highs are automatically
boosted when volume is lowered, to compensate for
insufficient bass and treble.
mw 6 inputs: PHONO, TUNER, CD, LINE, TAPE 1/DAT,
TAPE 2/ADAPTOR.
gm Large insulators
mw Connections for two pairs of speaker systems.
INSTALLATION
LOCATION
Install the amplifier in a well-ventilated location where it
will not be exposed to high temperature or humidity.
Do not install the amplifier in a location which is exposed to direct rays
of the sun, or near to hot appliances or radiators. Excessive heat can
adversely affect the cabinet and internal components. Installation of
the amplifier in a damp or dusty environment may result in malfunction
or accident.
(Also avoid installation near cookers étc., where the
amplifier may be exposed to smoke from oil, steam or heat.)
2
<ARB1355>
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet as
this could cause a short circuit or electric shock. Do not place the unit,
a piece of furniture, etc., on the power cord, or pinch the cord. Never
make a knot in the cord or tie it with other cords. The power cords
should be routed such that they are not likely to be stepped on. A
damaged power cord can cause fire or give you an electrical shock.
Check the power cord once in a while. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement.
MAINTENANCE OF EXTERNAL SURFACES
e Use a polishing cloth or dry cloth to wipe off dust and dirt.
¢ When the surfaces are very dirty, wipe with a soft cloth dipped in
some neutral cleanser diluted five or six times with water, and wrung
out well, and then wipe again with a dry cloth. Do not use furniture
wax or cleaners.
© Never use thinners, benzine, insecticide sprays and other chemicals
on or near this unit, since these will corrode the surfaces.
Advertisement
Table of Contents
