Black & Decker SD1000 Instruction Manual page 4

Charger Mounting
Instructions
(Figures 1 & 2)
1. The plastic bag supplied with
your tool contains
two wood screws and two plastic
wall anchors. Use the
anchors and screws to mount
the charger to dry wall and use
the wood
screws only to mount it to a wooden surface.
(The charger need not be
hung at all to operate
properly).
2. To use the plastic wall
anchors drill a 3/16" hole in
the dry wall where you will be
installing the anchor.
(Mark the desired place by holding
the charger base against
« the
wall and inserting a pencil through one of the two mounting
holes.) Don't forget
to locate the charger base within 4 feet of a wall outlet. Carefully
examine Figure
2 for proper
mounting.
3.
Insert the plastic wall anchor and tap it lightly with a hammer to seat it
flush
to
the wall. Position the charger base over the anchor and use one of the wood
screws
to hold the charger base on the wall. Repeat the process for the other mounting
hole in the charger base.
4.
When mounting the charger base to a wooden surface, drill
3/32" pilot holes for
the
wood screws. The plastic wall anchors should not be used
when hanging the
charger base on a wooden wall.
5. Hang the charger base vertically or horizontally as shown in Figure 2.
6. Hang the extra cord so it's out of the way.