U-Line Echelon CO2075FF Supplementary Manual page 2

Installation Instructions
Removing Existing Door
1. Remove the door shelves by first pulling shelves up at
a 45° angle, then straight out.
2. Remove top hinge screw pin (Phillips screwdriver).
Remove the door by tilting forward and lifting off the
bottom hinge pin.
3. Pull door gasket out of the groove (top edge of door
only). Start in the middle and pull outward, moving
toward the edge (see Figure 1). This may take some
force.
Figure 1
4. Remove the two screws located on both sides of the
handle.
5. Remove the door panel from the door.
6. Discard the old door.
Preparing the old panel for the new door:
1. Remove the existing metal panel backer.
2. Remove the existing L-shaped angle bracket in the top
corner.
3. Modify the notch in the top corner of the door. The
width needs to be changed to 1" (see Figure 3).
Remove this
Material
Old
Figure 3
4. Create an identical notch in the bottom corner of the
door, directly under this notch - 1" wide by 1/8" high by
3/4" deep (see Figure 4).
www.U-LineService.com
Old Handle
New Handle
Figure 2 ULIN_0403_A
New
ULIN_0358_A
1"
Figure 4
Attaching the Full Overlay Panel
1. Place and tape the existing door panel on the back of
the overlay panel (see Figure 5) and drill holes
through both panels according to Figure 6. Remove
tape adjoining the panels and enlarge the six holes in
the overlay panel using a 0.201" (#7) drill.
2. If a user-supplied cabinet handle will be used, attach its
hardware to the overlay panel at this time.
Back of
Wood
Panel
Side of
Wood Panel
7/16"
Bottom
Figure 5
Drill ø 5/32" x 3/8" Deep
7 Places Model 2175
6 places Model 2115 and CLR2160
For use with #10 x 5/8"
Wood Screw and Nylon Spacer
1.5"
12.25"
For use on
Model 2175 Only
Figure 6
2
3/4"
1/8"
ULIN_0363_A
Tape
Removed
Door Panel
Wood Panel
3/8"
Both Sides
3"
16"
28-7/8"
1.5"
ULIN_0365 _A
Bottom of
± 1/4"
04/2006