Yamaha YZ 2020 Series Owner's Service Manual page 67

1. Plastic locking tie
2. Number plate band
3. Clutch cable
4. Engine stop switch lead
5. Mode switch lead
6. Warning light lead
7. Front brake hose
8. Cable guide
9. Start switch lead
10.Number plate
11.Warning light
A. Fasten the start switch lead to the handlebar
using the plastic locking tie. Do not cut the
end of the plastic locking tie.
B. Pass the clutch cable through the rear side of
the number plate band.
C. Fasten the engine stop switch lead and mode
switch lead to the handlebar using the plastic
locking tie. Do not cut the end of the plastic
locking tie.
D. 30–50
E. Vertical direction of vehicle
F. Pass the engine stop switch lead and mode
switch lead between the frame and the cable
guide.
G. Pass the warning light lead through the cable
guide.
H. Pass the front brake hose through the front
side of the number plate.
I. Pass the clutch cable through the guide of the
number plate.
J. Pass the start switch lead through the cable
guide.
K. Pass the start switch lead through the left
side of the number plate mounting bracket.
L. Insert the warning light into the bracket and
fasten it.
CABLE ROUTING DIAGRAM
2-22