Yamaha YZ 2020 Series Owner's Service Manual page 151

a
4
3
3. Tighten:
4. Install:
4
TIP
The clutch lever holder "1" should be installed
according to the dimensions shown.
5. Install:
TIP
• The engine stop switch "1" and the mode
• Pass the engine stop switch lead through the
4-37
• Lower handlebar holder nut
Lower handlebar holder nut
40 N·m (4.0 kgf·m, 30 lb·ft)
• Clutch lever holder "1"
• Clutch lever "2"
Clutch lever holder bolt
5 N·m (0.5 kgf·m, 3.7 lb·ft)
Clutch lever nut
4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
2
1
168 mm
(6.61 in)
• Engine stop switch "1"
• Mode switch "2"
• Clamp "3"
Engine stop switch screw
0.5 N·m (0.05 kgf·m, 0.37 lb·ft)
Screw (mode switch)
1.3 N·m (0.13 kgf·m, 0.95 lb·ft)
switch "2" should be installed according to the
dimensions shown.
middle of the clutch lever holder.
0 mm
(0 in)
1
0 mm
(0 in)
HANDLEBAR
30 50˚
FW D
2 3