Yamaha YZ 2020 Series Owner's Service Manual page 153

12.Install:
• Throttle cable housing "1"
• Screw (throttle cable housings) "2"
Screw (throttle cable housings)
3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
EWA19310
WARNING
After tightening the throttle cable housing
screws, check that the throttle grip "3"
moves smoothly. If it does not, retighten the
screws for adjustment.
13.Install:
• Rubber cover "1"
• Cover (throttle cable housings) "2"
14.Install:
• Start switch "1"
• Front brake master cylinder assembly "2"
• Front brake master cylinder holder "3"
• Bolt (brake master cylinder holder) "4"
• Clamp "5"
Front brake master cylinder hold-
er bolt
9 N·m (0.9 kgf·m, 6.6 lb·ft)
TIP
• Install the brake master cylinder holder with the
"UP" mark facing up.
• Install in order for the top of the front brake
master cylinder assembly to be level.
• First, tighten the upper bolt, then the lower bolt.
3
2
5
4
15.Adjust:
• Throttle grip free play
Refer to "CHECKING THE THROTTLE
GRIP" on page 3-11.
4-39
HANDLEBAR
4
1