Norton clipper CFP13 W B Operating Instructions Manual page 10

VERS. 2023.03.15
Handle (1)
Jig welded steel construction is connected by 4 shockmount on the frame of the machine to reduce
the vibrations reach the operator
Belt drive and belt cover (2)
A centrifugal clutch inside the engine pulley drives the gear shaft through V-Belts. It allows to gradually
engaging the vibration of the machine. The drive assembly is enclosed in a metal guard.
Water tank (3)
Resistant plastic water tank
Battery motor and control panel (4)
The eGX battery engine from Honda which integrates the battery directly on the engine
On the control panel you can find:
- The Power button
- The ON/OFF switch
- The 3 LEDs (green, orange and red) to indicate the state of the motor
Lifting eye (5)
To lift the machine easily and safely, a lifting eye is located over the engine. This allows a balanced
lifting of the machine.
Eccentric element (6)
In our compactors the system of eccentric elements has been optimized by moving the weight to the
right side of the axle, so that less weight counteracts the movement at start-up.
Less power is required to initiate the vibratory action, reducing energy consumption at start-up by
50%.
Plate (7)
The plates have rounded edges and raised to avoid marking the surface
Shock absorbers (8)
The engine supporting and the compacting plates are connected by 4 shockmount, which are
mounted to avoid that vibrations reach the operator.
10
CFP13 W B _MAN_ EN