Preparing The Coating Material; Table Of Viscosities And Nozzle Sets; Starting Operation; Setting The Finecoat Spray Gun - WAGNER FineCoat 8800 Operating Manual

Preparing the coating material

Observe the manufacturer's instructions for the use of the
coating material on the paint tin or on the technical
instruction sheet.
Coating material purity:
An absolute pre-condition for the trouble-free operation of
the fine-spray system is that the coating material is
uncontaminated. If you have doubts as to the purity of
the coating material, we recommend that you first filter it
through a fine sieve.

Table of viscosities and nozzle sets

Viscosity DIN-s
Coating material
(4 mm DIN cup)
Solvent-based
lacquer paints
Water-soluble
lacquer paints manufacturer's
Wood preservatives
(scumble,
mordants, etc.)
Multi-color effect observe manu-
materials, multi-
color paint
Texture and effect observe manu-
paints facturer's instruc-

Starting operation

Before connecting to the mains supply make sure that the
mains voltage corresponds to the operating voltage on
the rating plate. The unit must be connected with a
properly earthed shockproof socket.
1. Screw air hose end (anti-kink spring) onto the turbo-
blower.
Couple air hose to the paint spray gun.
2. Open closing lever on the paint container, remove
paint container.
3. Fill paint container with coating material.
4. Check that the paint container seal is clean and is
seated correctly.
5. Clip the container onto the spray gun and secure with
the closing lever.
6. Switch the turbo-blower on.
7. Point the paint spray gun at the object to be sprayed.
8. Determine the settings for the spray pattern, spray
jet width, amount of material, amount of air and
ascending feed pipe settings, see fig. 2 - 8 and the
description page 15/16.
9. Operate trigger on the paint spray gun.
Nozzle set
No.
3 - 4
15 - 45
observe 4 - 5
instructions
undiluted 2 - 3
6 - 7
facturer's
instructions
5 - 6
g

Setting the FineCoat spray gun

Spray pattern selection (fig. 2)
A = vertical flat jet for horizontal surfaces
B = horizontal flat jet for vertical surfaces
C = round jet for corners and edges and
places difficult to access.
A
Setting the required spray pattern (fig. 3)
Turn the air cap (1) to the required spray pattern position.
Attention:
Never pull trigger while adjusting the air cap settings.
1
15
B C