Table of Contents
Advertisement
DSfT-Svi Owner's Manual (
Before operating the
DMT-8vl)
5. Input monitor and Repro monitor
There are
two
ways to monitor track data on the recorder: Input monitor and
Repro monitor. These are defined as follows:
Input monitor:
Input monitoring enables you to listen to the input signal that is routed to and
output through the tracks just as it is. That is, listening to (monitoring) the post-
recorder input signal (not the pre recorder signal). Eight tracks on the DMT-8vl
can be set to either "Input monitoring" or "Repro monitoring* status. Follow the
steps below to set the tracks to Input monitor.
1.
Set the track to recording status.
To set the track to recording status, first ready the track, the press the PLAY
button while holding down the RECORD button. At this time, the recording
track is In Input monitoring status.
i ttre RECORD
TRACK select key.
Pres* T* RECORD
button ard PLAY
button, or prssfiorSy
r* RECORD button.
Alternatively,
2. Ready the track, and press the RECORD button once. (If you press the RECORD
button again, the track enters the repro monitoring statue.)
•er 58 p.SB q
.a a a a a a
(Q;
? E2
: I
30. 00. 00,
B
00, GO.
m> (UipU, .OT0. the.
r*f
toy* pr*v>»d
only the RECORD TRACK nisei key i A and tie
Track 11s In ready moos. The rrtcator of ff* track
n ready mode veil birfc It you perform one ol txi
aporeuons described above, the seiocted track wfl
be set m Vpul monaohny' status.
f
"
■
■ -
" ■
"*v
• At
this
time, the
RECORD LED
next to the
RECORD
button wNt flash, and the
currency selected tracks wiH enter input monitoring status.
Repro monitor:
Repro monitoring enables you to monitor the playback signal on the tracks;
that is, to listen to the output of the recorded signal.
.pure*)
37
Advertisement
Table of Contents
