Table of Contents
Advertisement
DS1T-8VL Owner's Manual (SETUP mode)
f^To caned a selection orquftSefcp mode. pcm the STOP button or the EXIT/NO key.
Pressing the STOP button or the EXTT7NO key repeaiodty will stop you beck through
the previous settings, then qu« Setup mode_
I Follow the procedure below to clear all stored beat/tempo data
* While "BAR* it blinking, turn the JOG dial counter-clockwise.
The informa tier) on the first measure will appear, followed by subsequent Information,
The beat data and the tempo data {explained later) hill be ready for the al)<lear operation.
Bin*
2.
Preet the EXECUTE/YES key.
All stored time signature and tempo data will be cleared, and the default setting will be
restored.
f*~1 you do not wane to deer ail of the time signature and tempo data, pro** the STOP
button or the EXIT/NO key.
<Note>
If you attempt to enter bme signature and tempo data in a position that exceeds the
maximum recording tome. the value wd be not effective
3. Tempo setting ("TEMPO")
The Setup TEMPO" allow* you to set the tempo on the tempo map.
You can set up to 64 points in the range of quarter note - 30 to 250 at any position
in the song (If it has been structured by the beat settings). For example, you can
set a specific tempo value on a specific heat in the certain measure.
The setting sequence is "BAR" •> "
J
• •> TEMPO."
1.
Press the STORE key while pressing and holding down the HOLD/> key to select
a Program.
2
Press the DtSP SEL key to select "SETUP* and press the EXECUTE/YES key.
("SETUP" wit Hght up.)
Then, use the JOG dial to select TEMPO* (Minting) and press the EXECUTE/YES key.
(TEMPO" will light up.) At this rime. turning the JOG dial allows you to check the current
tempo settings one by one. (The default value for the first beat of the first bar Is 120. This
means that unless you set a different tempo after the first beat of the first measure, the
3.
Press the EXECUTE/YES key again.
"BAR* on the display will Mink. Indicating that "BAR" (measure) can be edited no*.
Use the HOLD/> key or SHUTTLE dial to select a desirable editing item (mBARrt. "J *, or
TEMPO"), modify (he value using the JOG dial, and press the EXECUTETTS key.
114
Advertisement
Table of Contents
