i-PRO WV-X35000 Series Installation Manual page 2

Disposal of Old Equipment and Batteries
Only for European Union and countries with recycling systems
These symbols on the products, packaging, and/or accompanying documents mean that used
electrical and electronic products and batteries must not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take
them to applicable collection points in accordance with your national legislation.
By disposing of them correctly, you will help to save valuable resources and prevent any potential
negative effects on human health and the environment.
For more information about collection and recycling, please contact your local authority.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national
legislation.
Note for the battery symbol (bottom symbol)
This symbol might be used in combination with a chemical symbol. In this case it complies with
the requirement set by the Directive for the chemical involved.
For U.S.A.
NOTE: This equipment has been tested and
found to comply with the limits for a Class A digi-
tal device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial environ-
ment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed
and used in accordance with the instruction man-
ual, may cause harmful interference to radio com-
munications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case
the user will be required to correct the interfer-
ence at his own expense.
For U.S.A.
The model number and serial number of this
product may be found on the surface of the
unit.
You should note the model number and serial
number of this unit in the space provided and
retain this book as a permanent record of your
purchase to aid identification in the event of
theft.
Model No.
Serial No.
Méthode d'installation
Monter directement la caméra vidéo sur la surface
d'installation.
Installer la caméra vidéo sur une boîte de groupe/
boîte de jonction double.
Installer la caméra vidéo à l'aide de la platine de
fixation d'installation exclusivement conçue.
* La longueur de la vis est un exemple lors de l'installation de la caméra au plafond ou sur un mur
robuste d'une épaisseur de 20 mm {25/32 pouces} ou plus.
FCC CAUTION: Changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
Supplier's Declaration of conformity
Trade name : i-PRO
Model No. : WV-X35402-F2LM, WV-X35302-F2LM
WV-X35402-F2L, WV-X35302-F2L
WV-S35402-F2L, WV-S35302-F2L
WV-S32402-F2L, WV-S32302-F2L
Responsible Party :
i-PRO Americas Inc.
8550 Fallbrook Drive, Suite 200 Houston,
Texas 77064
Support Contact: 1-800-513-5417
For U.S.A.
This device complies with part 15 of the FCC
Rules.
Operation is subject to the following two condi-
tions : (1) This device may not cause harmful
interference, and (2) this device must accept
any interference received, including interference
that may cause undesired operation.
For Canada
CAN ICES-3(A)/NMB-3(A)
Vis de fixation recommandée
M4 x 16 mm {5/8 pouces}* /
2 él.
Se référer au manuel d'utilisation de chaque platine
de fixation.
2
La capacité de traction
minimale requise
196 N {44 lbf}