Table of Contents
Advertisement
Tape Operation
Search
System
For each recording, an invisible index mark is placed
on the tape. A program index and information are also
included for timer recordings. These marks are used to
access or scan recordings.
Index Search
Program End Search
Locates end
point of recording
for
to display SEARCH
to select recording
PROGRAM
number.
END SEARCH.
* To calculate
number, see below.
Press FF or REW
to start search.
Examples of Program End Search.
Fig. 1
-
* Play begins at
search end. To
=
I4 —
|
search forward or
Press SEARA boton
End Point
.
back 1 index,
=
press FF or REW
Fig. 2
while screen left
is displayed (10
sec.).
:
Bl To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
gr
OG
NON
Em:
|
|
| s | 5
7
Example 2:
j
To go tọ rec. 6 from rec. 2, enter 4 and press FF.
Upon locating end point,
NON
NN
-->search continues 7 sec. past end point,
-->tape rewinds to t0 sec. before end point,
-->tape plays to end point and stops.
1 | BIN
ME
5 — 7
NOTE: 4 indicates start points of each recording.
co
* If Index Search is started very close to
* If Program End Search is started very
an index mark, that index mark may not
close to an index mark, that mark may be
be counted in the search.
skipped over.
* To cancel, press PLAY or STOP.
For assistance. please call : 1-600-211-PANA(7262) or send e-mail to : consumerproducts
@ panasonic.com
Advertisement
Table of Contents
