Table of Contents
Advertisement
"Important: If a remote contro! bution does not work when pressed, press
the VCR button on the remote and try the bution again.
Auto VCR Plus+ System Channel Setup (Part 2)
Before you perform the following steps, you
should have:
* completed "Auto VCR Plus+ System Channel
Setup (Part 1)" on page 18.
* left VCR off overnight, and turned it back on after
SELECT/
. SET
9:00 AMthe next day.
A :PLAY
Y :STOP
It channel updating was If
|
«:REW
ACTION
ADD/DLT
Press ACTION
Press ACTION
to exit this mode.
to display SELECT VCR
Plus+ CH.
y
Continue with step 2.
O
O
Press AV 4b
to select
o
channel map for your area
Q.
and
5
press ADD/DLT to set.
To Change or Update Auto VCR
©
Plus+ System Channel Setup
(E.g. you selected wrong channel
map or zip code.)
Press ACTION
a Do "Auto VCR Plus+ System
PLEASE LEAVE VER OFE
to end.
Channel Setup (Part 1)" steps
OVERNIGHT
1~4 on page 18.
* Make sure to leave
VCR off (overnight.)
ATE VEA PE. DH
SI
VCR
Plus+
C
Channel map will be updated (overnight.)
b Press AW toselect UPDATE VCR
If it was
successful,
"VCR
Plus+
CH
SET
Plus+ or SELECT
VCR Plus+ CH
COMPLETED" appears on screen. And then,
thenpressP.
t
press ACTION to exit.
c Ifyouselected UPDATE VCR Plus+
CH, perform steps 5-7 in the "Auto
VCR Plus+ System Channel Setup
(Part 1)" section on page 18.
Channel Setup" on page 20.
CH. perform steps 2-3 in the "Auto
VCR Pius+ System Channel Setup
(Part 2)" section on this page.
Repeat these steps as necessary.
19
Advertisement
Table of Contents
