universalblue BALI 4008W User Manual page 67

• Power connection:
• Do not use a wiring board or anything
similar.
• If the wires are damaged, contact a
professional for immediate repair.
• After using the washer, unplug it and
shut down the water supply.
• Connect the washing machine to a
grounded outlet.
• Place the washing machine where it
has an easy outlet connection.
• Contact the
and ask a professional to repair the
washing machine.
• Do not place the washing machine
in a location where the temperature
is below freezing. The pipes will
freeze and break.
temperature below zero will damage
the programming controller.
• Grounding Introduction: A washing
machine must
grounding devices. If any problems
arise, this device can reduce the risk of
electrical shock. The device is equipped
with a wire that includes a grounded
plug. If you want to know if your
washing machine is properly grounded,
contact your service personnel.
• If your washing machine emits smoke
or an unusual odor, cut the power and
contact professional maintenance staff.
• Water: Washing machines must have a
water inlet. To ensure proper operation,
water injection tests are performed
before the washing machine leaves the
factory, so there may be water inside
the drum.
• Water inlet connection (see pictures 04,
05 and 06 on page 5):
11. Standard faucet
12. Longer faucet
13. Square faucet
14. Water pipe connector rubber gasket
15. Water pipe connector rubber gasket
• The water supply pressure should be
between 30kPa and 1000kPa.
• Do not force
connecting the inlet pipes to the
valves.
• Two seals are
maintenance center
Moreover,
be connected
the thread when
supplied in
connectors of both ends of the pipe to
prevent water leaking.
• Open the tap and check if the
connectors leak.
• Check the pipes regularly and replace
them if necessary.
• Make sure that the pipes are not
damaged or entangled with each
other.
The connection of inlet pipes and taps (see
picture sequence 07 on page 5):
16. Rubber seal
17. Water hose
18. Water inlet
• Check the rubber seals on both sides
of the hose. Insert a rubber seal into
the the threaded fittings on each hose to
prevent leaking.
• Connect the water supply hoses to
the water faucets tightly by hand and
to then tighten another 2/3 turn with
pliers. Connect the blue hose to water
faucet.
• After connecting inlet hose to water
faucets, tum on the water faucets to
flush out foreign substances (dirt,
sand or sawdust) in the water lines.
Let water drain into a bucket, and
check the water temperature.
• Connect the hoses to the water
inlet tightly by hand and the tighten
another 2/3 turn with pliers.
• Check for leaks by turning on the
faucets. If water leaks, check steps 1 to
4 again.
Do not overtighten. Damage
to the coupling can result.
Installing the drain pipe (see picture
08 on page 5):
19. Wash tube
20. Pipe holder
21. Wire harness
• Secure the drainpipe with a lifting
rope.
the • The height of the drainpipe should be
EN
67