universalblue BALI 4008W User Manual page 16

TABLAS · TABLES · TABELAS ·
La pantalla indica "LE"
o "CE" cuando el tambor
no gira
Espuma excesiva
Problem
The washing machine
will not start.
The display shows "UE"
during the spin cycle.
Display shows "IE"
during water inlet
The display shows "OE"
during water outlet.
The display shows
"DE" which is a door
problem.
The display shows "I:E"
which is a non-heating
problem.
The display shows
"FE" during continuous
water inlet.
The display indicates
"LE" or "CE" when the
drum does not rotate.
Excessive foam.
16
Cierra el grifo, quite el enchufe y llame al servicio posventa.
Compruebe si se ha añadido demasiado
detergente.
Compruebe si se ha añadido demasiado
detergente.
Check points
Check whether the on/off or start/pause button
has been pressed.
Is the washing machine plugged in?
Is there a power failure?
Check whether the leakage protector is cut off.
Check whether the transport bolts have been
removed.
Is the machine firmly installed?
Are the clothes too small or too light?
Are the locking nuts under the legs tight?
Check if the tap is turned off.
Check if the water supply is turned off or the
water pressure is too low.
Are the water inlet pipes frozen?
Are the filters blocked?
Are the water outlet pipes set too high?
Are the water outlet pipes frozen?
Are the water outlet pipes blocked?
Is the floor drain blocked?
Check if the washing machine has started
without properly closing the door.
Remove the plug and call the after-sales service
Turn off the tap, remove the plug and call the after-sales service.
Turn off the tap, remove the plug and call the after-sales service.
Check if too much detergent has been added.
Check if too much detergent has been added.
Añada una cantidad de detergente
razonable.
Use el detergente correctamente.
Solutions
Press the on/off or start/pause button.
Plug in the power plug.
Please wait.
Open the leakage protector.
Remove the transport bolts.
Place the machine on a stable floor.
Add more clothes.
Tighten the locking nuts.
Open the faucet.
Please wait.
Use hot water to thaw the pipes.
Remove the filters and clean them.
Pull out the water outlet pipes and make
sure that the height is 1m max.
Use hot water to thaw the pipes.
Remove foreign particles and clean the
pipes.
Clean the floor drain.
Check that the door is properly closed.
Add a reasonable amount of detergent.
Use detergent properly.