Eventide RIPTIDE Quick Reference Manual page 3

Presets
5 On Board, 127 Via MIDI
The current Preset is indicated on the Preset LED Ladder. When a Preset is modified the Preset LED blinks once.
Perform and Preset Modes
Press and hold Vibe Footswitch to toggle between
Perform and Preset Modes. Preset LEDs will blink twice.
Perform Mode: Footswitches turn Drive and Vibe
effects on and off, and the corresponding LED Buttons
toggle between 2 available voicings (Green or Red).
Preset Mode: Vibe Footswitch selects Preset 1–5, and
Drive Footswitch controls Pedal Active/Bypass.
Catch Up Knob Function
When loading a new Preset, knob positions will not
align with their current parameter values. As a result,
turning a knob will likely cause an audibly abrupt
change. With Catch Up enabled, the sound does not
change until the Knob is moved to the position of the
current value.
See "System Setup" on how to enable Catch Up.
Save Preset
To save one of the five onboard Presets:
1. Press and hold Vibe LED Button. Blinking Ladder LEDs
and LED Buttons indicate you have entered Save Mode.
2. Press Vibe LED Button to select Preset 1–5.
3. Press Drive LED Button to save Preset.
LEDs stop blinking to let you know the Preset is saved.
NOTE: Save Mode times out after a few seconds.
Pressing either Footswitch exits Save Mode.
Load Presets
In Presets Mode, to select and load a Preset:
1. Press Vibe Footswitch to select Preset 1–5.
Preset 1 (top LED) to Preset 5 (bottom LED) blinks.
2. Press Drive Footswitch to load the Preset.
LED stops blinking.