Fisher & Paykel 11 Series User Manual page 58

WASHER
ALERTS
DOOR LOCKED
AUTO
DETERGENT
LOW
AUTO
SOFTENER LOW
FILTER
BLOCKED
HIGH TEMP
WATER LEVEL
ADD ITEM
DRYER
ALERTS
CHECK FILTERS
WATER TANK
FULL
COOLING DOWN
ROOM TEMP
LOW
ROOM TEMP
HIGH
MAX TIME
REACHED
58
WHAT TO DO
The temperature in the drum is over 60°C therefore it is not safe to open the
door. Wait until the temperature drops below 60°C.
Check the water level in the drum. If the level is above the bottom
of the door seal, the door cannot be opened. Use
add or remove items.
If the drum is still moving, wait for it to stop before attempting to open
the door.
is enabled, refer to 'Wi-Fi connection and Remote mode'
REMOTE MODE
Refill
AUTO DOSE DETERGENT
Take care to not fill beyond the
Refill
AUTO DOSE SOFTENER
the mark.
MAX
The pump filter is blocked and needs to be cleaned.
Refer to 'Cleaning the pump filters'.
Door may remain locked due to high temperature in drum.
Wait for temp to reduce then try again.
Water level is too high. If this occurs, disconnect power and water
and contact Fisher & Paykel Customer Care.
Wait for the door to unlock. The washer may need to lower its water level
and/or wait for a safer drum temperature before unlocking.
WHAT TO DO
Clean lint and condenser filters and carefully vacuum the evaporator grid.
Check the lint filter or condenser filter are not damaged.
Check there is nothing else trapped in the filters or evaporator grid,
which may be blocking the air flow.
Check if the water tank is full.
Empty the water tank.
If using the drain hose, check whether the water tank or drain hose
is blocked.
Check the drain hose is still attached at the back of the machine, and is not
kinked or squashed.
Wait for the dryer to cool. The cycle will resume once the drum has cooled.
The room temperature is too low for the dryer to work effectively. Ensure
that the room temperature is above 5°C to avoid loss of efficiency.
The room temperature is too hot for the dryer to work effectively. Wait for
environment to cool before resuming.
There are a number of reasons the maximum cycle time might be reached.
Refer to 'Dryer troubleshooting'.
FAULT CODES
compartment or switch to
mark.
MAX
compartment. Take care to not fill beyond
if you wish to
ADD ITEM
.
MANUAL