Sony KP-48V80 Operating Instructions Manual page 57

Operating a Cable Box or Satellite Receiver (SAT)
Setting the Manufacturer's
Code
Manufacturer code numbers
(satellite receiver)
You can program the supplied remote control
to operate a cable box or satellite receiver.
Geneal Electric
Press CODE SET, SAT/CABLE Hitachi
(FUNCTION), and the 0-9 buttons to enter Hughes
the manufacturer's code number (see the Panasonic
following chart), then press ENTER. RCNPROSCAN
Toshiba
For example, to operate a Sony satellite
receiver:
FU_'3]0N
Manufacturer code numbers
(cable box)
Manufacturer
Code
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. I. 201,202, 203, 204, 205,
222, 206, 207, 208, 218
Oak 227, 228, 229
Panasonic 219, 220, 221
Pioneer 214, 215
Scientific Atlanta 209, 210, 21 t
Tocom 216, 217
Zenith 212, 213
Manufacturer
Sony
Code number
801 (preset code for
remote control)
802, 808
805
804
803
802
806, 807
To operate the cable box or
satellite receiver (SAT)
1
Press SAT/CABLE (POWER) [Green
Button] to turn on/off the cable box or
satellite receiver.
2 Press SAT/CABLE (FUNCTION).
3 For other operations, refer to the
operating instructions that come with the
equipment.
The GUIDE and INDEX (blue-labeled)
buttons can be used only with a satellite
receiver.
If the remote control doesn't work
• Try repeating the set up procedures using
the other codes listed for your equipment.
To operate the projection
TV
Press TV (FUNCTION). Then use the
projection TV control buttons to control the
projection TV.
• Ifmorethanonecodenumberislisted, tryentering
them one by one until you come to the correct code for
your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
Whenever you remove the batteries -- to replace
them, for example -- if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
53