Sony KP-48V80 Operating Instructions Manual page 15

Connecting two VCRs for tape
editing
By connecting a second VCR to MONITOR
OUT, you can record a program being played
by the primary VCR to the second VCR or
perform tape editing and dubbing.
] Connect the VCR intended for playback
using the connection instructions on page
6 of this manual.
2 Using an AUDIO/VIDEO
cable, connect
AUDIO and VIDEO IN on the VCR
intended for recording to AUDIO and
VIDEO OUT of MONITOR OUT on the
projection TV.
Notes:
• Do not change the input signal while
editing through MONITOR OUT.
• When connecting a single VCR to the
projection TV: if VCR LINE OUT is
connected to VIDEO IN on the projection
TV, do not connect MONITOR OUT on
the projection TV to the VCR LINE
INPUT (see right). Doing so will cause
program interference and other viewing
problems.
VCR (for playback)
1_ AUDIO-R-_II
AUDIO-L_ III
ViDEO-- 7
VMC-S10S/820S T
(not s_pplied) J
Disconnect all power sources before making any connections.
(Rear of projection IV)
-o, 1._
VIDEO
AUDIO-L
AUDIO-R
VMC-810S/820S
(not s_pplied)
VCR (for recording)
{
(Rear of projectionTV)
Indicates
FI,_
of signal
VCR
direction
11