Download
Share
Print this page
  1. Manuals
  2. Brands
  3. TentCraft Manuals
  4. Tent
  5. X Series
  6. Setup instructions

TentCraft X Series Setup Instructions

Hide thumbs Also See for X Series:

Advertisement

Quick Links

Download this manual
20x30
X-SERIES |
SETUP INSTRUCTIONS

Advertisement

loading
Need help?

Need help?

Do you have a question about the X Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for TentCraft X Series

Summary of Contents for TentCraft X Series

  • Page 1 20x30 X-SERIES | SETUP INSTRUCTIONS...

  • Page 2: Job Number

    X-SERIES | 20x30 THANK YOU FOR PURCHASING A 20x30 | X-SERIES TENT! If you hav (800)950-4553 ay hav y ov MODEL SIZE JOB NUMBER TentCr TentCr TentCr...
  • Page 3 X-SERIES | 20x30 HERE’S WHAT YOU’RE WORKIN’ WITH... Qty: 10 - 7’ Legs (84”) Qty: 8 - Tent Top Straps Qty: 2 - Crown Clusters Qty: 10 - Perimeter Poles (112”) Qty: 6 - Intermediate Brackets Qty: 10 - OutGuy Straps Qty: 6 - Intermediate Rafters (128”) Qty: 4 - Hip Poles (172”) Qty: 10 - 3’...
  • Page 4 X-SERIES | 20x30 Step 1 Inspect the tent site thoroughly for obstacles, underground and overhead wires, pipes, etc. If necessary, consult with your local utility company prior to installation. Step 2 assembly. Do not install legs or roof rafters at this time. Step 3 Begin assembly of the frame by inserting the perimeter poles into the Step 4...
  • Page 5 X-SERIES | 20x30 Step 5 Step 6 Step 7 Step 8 Lift one of the 30’ sides of the frame and install the legs along that side. Install the corner legs before the intermediate legs.
  • Page 6 X-SERIES | 20x30 Step 9 the previous step. Step 10 Step 11 Attach tent top to the frame with the tent top straps. Bring the “Y” straps (located at the very top of the tent top straps) through the metal rings on each of the tent top valances and secure the looped ends of the “Y”...
  • Page 7 X-SERIES | 20x30 Step 13 Locate the two intermediate poles on both 30’ sides of the tent. On the valance, where it comes down to a point and meets the pole, a single metal ring is sewn onto the inside of the tent top. Attach the carabiner at the top of the tent top strap to this metal ring.
  • Page 8 X-SERIES | 20x30 Step 17 outguy strap length into the white vinyl covers with velcro closure.
  • Page 9 X-SERIES | 20x30 are approximate and are experience. Windload of a t upon the style of type of tent. The structural integrity of the tent may exceed the soil's holding capacity even at wind loads of 30 to 50 mph. Frame tents require approximately 1000 to 2000 lbs of holding power per anchor location (dependent on the size and style of the tent).
  • Page 10 X-SERIES | 20x30 Note: The tent must be anchored properly for safe installation. Additonal guys and stakes may be required depending on soil and/or wind conditions. Refer to the IFAI Procedural Handbook for Safe Installation and Maintenance of Tentage for calculating the proper anchoring capacity for soil and or ground conditions.