Download Print this page

TentCraft MONARCHSTOREFRONT How To Set Up

Billboard style pop-up tent with 4-legs

HOW

TO SETUP

MONARCHSTOREFRONT

Billboard Style Pop-Up Tent With 4-Legs

Table of Contents

Need help?

Do you have a question about the MONARCHSTOREFRONT and is the answer not in the manual?

Page 1 TO SETUP MONARCHSTOREFRONT Billboard Style Pop-Up Tent With 4-Legs...
Page 2 Remove the tent from the shipping box and transit bag. Have two people stand on opposite sides of the tent. (If your setup includes a peak banner, install the hardware into the peak cap now.) Have each person grab the scissor piece and walk backwards, gradually expanding the tent frame until you reach full extension.
Page 3 Get under the tent and connect the two halves of the floating center poles. Holding the tent down with your foot on the foot pad, press up on the scissor piece attached to the corner bracket as it slides up the leg and clicks into place.
Page 4 Get under the tent. Locate the valance straps in the center of each valance. Wrap the long end of the strap down and back up through the connecting element, then snap the buckle together. Pull on the strap to tighten until the valance itself is taut.
Page 5 Standing again by the tent leg with your foot on the foot pad (as in Step 4), extend the leg by pressing the push button in and pulling up on the leg until it snaps into place. Repeat for this leg until you have reached desired height.
Page 6 Wheel Kit Instructions...