1. Manuals
  2. Brands
  3. TentCraft Manuals
  4. Tent
  5. S-Series
  6. Setup instructions

TentCraft S-Series Setup Instructions

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
15x15
S-SERIES |
SETUP INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S-Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for TentCraft S-Series

Summary of Contents for TentCraft S-Series

  • Page 1 15x15 S-SERIES | SETUP INSTRUCTIONS...
  • Page 2 SIZE JOB NUMBER TentCraft Inc in no way represents the estimated holding power to be true in all cases. It is an estimate, and as such, does not imply that the figures are sufficient to hold any tent securely in windy or adverse weather conditions.
  • Page 3 S-SERIES | 15x15 HERE’S WHAT YOU’RE WORKIN’ WITH... Qty: 4 - 8’ Legs (96”) Qty: 4 - S-Series Tent Top Straps Qty: 4 - Corner Brackets Qty: 8 - Perimeter Poles (81”) Qty: 4 - OutGuy Straps Qty: 4 - Baseplates Qty: 1 - Center Pole (83”)
  • Page 4 S-SERIES | 15x15 Step 1 Inspect the tent site thoroughly for obstacles, underground and overhead wires, pipes, etc. If necessary, consult with your local utility company prior to installation. Step 2 Lay out the erection site by first placing the corner brackets, perimeter pole connectors and perimeter poles in sequence per the diagram to the left for assembly.
  • Page 5 S-SERIES | 15x15 Step 5 Unroll vinyl top across frame making sure the extra peak material is on top of the setup. Stretch the corner webbing loops sewn into the tent top over the cast eyelet on the outside of the corner bracket. Note that the last corner may be difficult to stretch over the eyelet, especially in cold conditions.
  • Page 6 S-SERIES | 15x15 Step 9 Attach tent top to the frame with the tent top straps. Bring the “Y” straps (located at the very top of the tent top straps) through the metal rings on each of the tent top valances and secure the looped ends of the “Y” straps into the carabiner.
  • Page 7 The installer is responsible for properly securing the temporary structure (tent). Soil conditions will vary and the wind loads that the temporary structure can handle could be significantly below its wind load capabilities. ** S-Series 15’x15’ engineering certification documents are available upon request.** Anchor Holding Power...

Table of Contents