Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for TentCraft X-Series
Summary of Contents for TentCraft X-Series
- Page 1 10x20 X-SERIES | SETUP INSTRUCTIONS...
-
Page 2: Job Number
SIZE JOB NUMBER TentCraft Inc in no way represents the estimated holding power to be true in all cases. It is an estimate, and as such, does not imply that the figures are sufficient to hold any tent securely in windy or adverse weather conditions. - Page 3 X-SERIES | 10x20 HERE’S WHAT YOU’RE WORKIN’ WITH... Qty: 2 - Intermediate Qty: 6 - 7’ Legs (84”) Qty: 2 - Crown Clusters Tent Top Straps Qty: 6 - Perimeter Poles (112”) Qty: 1 - Roof Rafter Bracket Qty: 4 - Tent Top Straps Qty: 2 - Intermediate Rafters (61”)
- Page 4 X-SERIES | 10x20 Step 1 Inspect the tent site thoroughly for obstacles, underground and overhead wires, pipes, etc. If necessary, consult with your local utility company prior to installation. Step 2 Lay out the erection site by first placing the corner brackets, intermediate brackets and perimeter poles in sequence per the diagram to the left for assembly.
- Page 5 X-SERIES | 10x20 Step 5 Install the crown cluster bracket by inserting both hip poles into the bracket. Repeat this step to install the second crown cluster. Once both crown cluster brackets are installed, put the roof rafter bracket into place by slipping it over the two intermediate poles - located in the middle of the setup.
- Page 6 X-SERIES | 10x20 Step 9 Lift the opposite 10’ side of the tent and insert the legs into the brackets as in the previous step. This will complete installation of the four corner legs. Make sure all snap pins are locked in place.
- Page 7 X-SERIES | 10x20 Step 13 Locate the intermediate poles on the 20’ sides of the tent. On the valance, where it comes down to a point and meets the pole, a single metal ring is sewn onto the inside of the tent top. Attach the carabiner at the top of the inter- mediate tent top strap to this metal ring.
- Page 8 X-SERIES | 10x20 Step 17 Once all stakes have been secured and straps ratcheted taut, fold all extra outguy strap length into the white vinyl covers with velcro closure.
- Page 9 X-SERIES | 10x20 Anchoring Requirements (Non-Certified Tents) Non-certified tents are not engineered to meet specific wind loads. Wind loads are approximate and are generally rule of thumb calculations used in the industry based on actual field experience. Windload of a non-certified tent will very to a maximum of approximately 30 to 50 mph dependent upon the style of type...
Need help?
Do you have a question about the X-Series and is the answer not in the manual?
Questions and answers