How To Use - Zanussi ZB 960 Instructions For The Use And Care

HOW TO USE
Operating Instructions
The cooker hood functions are controlled
by three slide switches, an automatic
microswitch and selector slide lever.
The three slide switches which are located
on the right hand side beneath the facia
panel control fan speed and work surface
illumination.
The switch marks with the fan symbol
and the 0-1 controls the power supply to
the fan. This should be used in
conjunction with the switch marked l-2>3
which controls the fan speed.
Position 1 should be selected when
simmering or when using only one pan.
Position 2 should be selected for normal
cooking, up to four pans.
Position 3 should be selected when frying
or cooking foods with strong odours.
The switch marked with the symbol inl¬
and 0-1 controls the power to the worktop
illumination.
The concealed microswitch acts as an
overide and will switch the hood off,
whatever selection is made with the slider
switches when the facia panel is closed.
When the panel is pulled open the hood
will resume working at its previous setting.
The changeover slide lever for selecting
recycling or exhaust mode is situated on
the diffuser behind the air inlet grille. To
open the grille press inwards on the two
slide catch fastners located in either side
of the lighting diffuser. The grille can be
lowered into an intermediate position, and
can be removed by moving the grille
through a 45 degree angle, away from the
hood. The inlet grille can be removed
while the door panel is in the operating
position. The charcoal filters should be
located onto the mounting in the centre of
the fan cover. In the recycling mode, air
passes through the grease filter and
charcoal and out through the ducts located
in the casing above the decor panel.
In the ducting mode, air passes through
the grease filter and out dirough the
ducting into the atmosphere.
To obtain the best performance it is
advisable to switch on the hood a few
minutes before commencing cooking and
leave it running for approximately 15
minutes are finishing.
Worktop Illumination
If the lamps fail to function at any time
first check they are fully screwed into the
holders. When changing the lamp, an
identical replacement must be fitted to
ensure safe working of the hood.
Replacement lamps are tulip shaped, clear
glass 240V 40W, small Edison E14 screw
thread.
7