Zanussi ZHI 600 Instruction Booklet
Zanussi ZHI 600 Instruction Booklet

Zanussi ZHI 600 Instruction Booklet

Integrated cooker hood

Advertisement

INSTRUCTION BOOKLET
INTEGRATED
COOKER HOOD
ZHI 600

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZHI 600

  • Page 1 INSTRUCTION BOOKLET INTEGRATED COOKER HOOD ZHI 600...
  • Page 2: Guarantee Conditions

    If you require guidance in the use of the appliance or require further information on Zanussi Products, please contact our Customer Care Department. For general enquiries concerning your Zanussi appliance or for further information, visit our website at http:\\www.zanussi.co.uk...
  • Page 3: Important Safety Information

    • Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunction. Refer to your local Zanussi Service Force Centre. Always insist on genuine spare parts.
  • Page 4: Your Appliance

    OPERATING INSTRUCTIONS This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. To obtain the best performance it is advisable to switch on the hood a few minutes before you start cooking and leave it running for approximately 15 minutes after finishing.
  • Page 5: Extraction Mode

    Extraction The contaminated air enters the hood passing through the grease filter and out through the ducting into the atmosphere. Recirculation A charcoal filter enables the cooker hood to recirculate the air back into the kitchen. When the extraction mode is selected the charcoal filter is not required.
  • Page 6: Maintenance And Cleaning

    MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent.
  • Page 7: Changing The Light Bulb

    The synthetic paper grease filter cannot be cleaned. It must not be washed. Charcoal Filter (for use in recirculation mode) The charcoal filter cannot be cleaned, it should be replaced approximately every three months or more often if the hood is used for more than three hours per day. To Remove the Charcoal Filter Remove the thumb screw through the center of the charcoal filter, from the motor support.
  • Page 8: Something Not Working

    For general assistance with your appliance or for information on Zanussi products please contact our Customer Care Department. Customer Care Department, Zanussi 55-77 High Street...
  • Page 9 STANDARD GUARANTEE CONDITIONS We, Zanussi Ltd., undertake that if within twenty four months of the date of the purchase this Zanussi built-in appliance or any part there of is proved to be defective by reason only of faulty workmanship or materials, the...
  • Page 10: Installation Instructions

    INSTALLATION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way. Technical Information DIMENSIONS WEIGHT ELECTRICAL SUPPLY: POWER CONSUMPTION: FAN MOTOR: LAMP: SUITABLE FOR INSTALLATION ABOVE: CHARCOAL FILTERS: Note: CE Marking certifies that this appliance complies with the requirements laid down in EEC directive 89:336.
  • Page 11: Installing The Cooker Hood

    INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood.
  • Page 12: Fitting The Wall Brackets

    Clearance Height A clearance height of 650mm (25 1/2 ”) is required when installed above a built-in electric hob, or 700mm (27 1/2 ”) when installed above a built-in gas hob. A clearance height of 685mm (27”) is required when installed above a slot-in electric cooker, or 787mm (30 1/2 ”) when installed above a slot-in gas cooker.
  • Page 13 Venting The hood is more effective when used in the extraction setting (ducted to the outside). Venting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of 100mm (4”) minimum. The ducting used must be manufactured from fire retardant material.
  • Page 14 Fitting the Cooker Hood to the Wall Fit the brackets with the round ends facing downwards using the plastic rawl plugs and screws provided. Once the brackets are secured, lift the hood squarely to the wall slightly higher than the brackets.
  • Page 15 Failure to align the top edge of the decor panel with the template will prevent the visor from opening when installed. Before drilling, use a tape measure to check the distances of the screw holes (as given on the template). The template may have altered due to dampness after manufacture.
  • Page 16: Customer Care Department

    Tel: + 353 (0)1 4090751 Email: service.eid@electrolux.ie Customer Care Department For general enquiries concerning your Zanussi appliance or for further information on Zanussi products please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.zanussi.co.uk...
  • Page 20 436002545 01 - 041222 © Electrolux plc 2002...

This manual is also suitable for:

Zh 280

Table of Contents