Table of Contents
Advertisement
srs -
STATUS
Purpose
Shows STS or STS M information about the following:
0
Breakpoints
0
Printpoints
0
Interrupts
0
Bus Requests
0
Refresh Function
0
GO or QUIT mode
The first three lines of the status display represent the first, second, and third
software breakpoints respectively. Each line reads like this:
o
The first entry represents the breakpoint address.
o
The second entry shows the pass counter.
o
The "E" or
"D"
indicates whether the breakpoint is enabled or disabled.
o
A "P" indicates that the printpoint is enabled. A blank indicates that the print-
point is disabled.
The fourth line of the status display shows the state of the interrupt, bus request,
refresh functions, and whether NICE is in GO mode or QUIT mode. An I, B, or R
indicates the function is enabled, while a period indicates the function is disabled.
The word "RUNNING" indicates that NICE is in GO mode.
STS
B
STS H
displays breakpoint status
displays performance monitoring bucket status
(see examples)
34.
Advertisement
Table of Contents
