Chapter 2 Set-Up; Terminal - Nice Z80+ Operation Manual

CHAPTER 2
SET-UP
There are two aspects to setting up NICE for 280 emulation:
1. Setting up the terminal,
2.
Establishing the communications interface and installing NICE into the target
system.
TERMINAL
Auto Baud Rate Detection
NICE is equipped with an automatic baud rate detection algorithm that is invoked
whenever NICE is powered up. To determine the proper baud rate, NICE measures
the length of the first start bit transmitted from the terminal. To start automatic
baud rate detection, enter a carriage return following power up. After the baud
rate has been determined, you will see the NICE prompt which, is a greater than
sign()). At this point, you may begin entering commands.
To work with NICE, the terminal must be set to one of the following baud rates:
0
1.50
0
2400
0
300
0
4800
0
600
0
9600
0
1200
0
19.2 k
Terminal Characteristics
To operate with NICE, the terminal must be set up with the following
character is tics:
o Full duplex operation
o Auto line feed on; carriage return disabled
o Line terminator set to either carriage return or line feed
o Destructive space enabled