Table of Contents
Advertisement
Inspection and Servicing/Cleaning
Vehicle Exterior Inspection
CAUTION
When removing the lens or lamp unit
using a flathead screwdriver, make sure
that the flathead screwdriver does not
contact the interior terminal. If the
flathead screwdriver contacts the
terminal, a short circuit may occur.
NOTE
When replacing a bulb, contact an
Authorized Mazda Dealer.
Use the protective cover and carton
for the replacement bulb to dispose
of the old bulb promptly and out of
the reach of children.
Replacing Exterior Light Bulbs
LED type
Headlights
Daytime running lights
Parking lights
Front turn signal lights
High-mount brake light
Rear turn signal lights
Brake lights
Taillights
Reverse lights
The LED bulb cannot be replaced as a
single unit because it is an integrated
unit.
The LED bulb has to be replaced with
the unit. If a replacement is necessary,
consult an Authorized Mazda Dealer.
9-36
MX-5_8ME4-EA-23L_Edition1_new
Bulb type
Side turn signal lights
1. Make sure the vehicle power is
switched off, and the headlight
switch is off.
2. If you are changing the left bulb,
start the engine, turn the steering
wheel all the way to the left, and
turn off engine. If you are changing
the right bulb, turn the steering
wheel to the right.
3. Pull the center of each plastic
retainer and remove the retainers,
and then partially peel back the
mudguard.
1. Removal
2. Installation
4. Remove the unit by pressing the tab
on the unit with your finger and
pulling the unit forward.
2023-8-31 16:47:34
Advertisement
Table of Contents
