2
Product Description
2.1
FL3X Tiny 3 Family at a glance
The FL3X Tiny 3 Family is a series of small interface modules with physical layer drivers. Module
information is stored in an EEPROM. The FL3X Tiny 3 Family modules are connected between protocol
devices and the bus cables. They offer bus termination functionality and shielding options depending on
the respective module. FL3X Tiny 3 Family modules are available for following bus systems:
•
FlexRay
•
CAN-FD (applicable for CAN-HS)
•
CAN-FD-SIC (applicable for CAN-HS and CAN-FD)
•
100MBit Ethernet (100BASE Tx)
•
100MBit 2 wire Ethernet (100BASE-T1)
•
1GBit 2 wire Ethernet (1000BASE-T1)
•
LIN/SENT
•
K-Line/UART/SPI
Field of application
The following STAR ELECTRONICS GmbH & Co. KG products are using FL3X Tiny 3 Family modules:
•
FL3X Device-S
•
FL3X Device-L
•
FL3X Device-L²
•
FlexDevice-L² HDSub (Rev.2)
•
FL3X Device-PXIe
•
FL3X Device-PCIe
2.2
Accessory Parts
For usage of FL3X Tiny 3 Family, the following parts are necessary:
•
FL3X Device-S/L/L², FlexDevice-L² HDSub (Rev.2) or FL3X Device-PXIe/PCIe (carrier device)
•
Application software, e.g. FL3X Config
For further information about accessories for the FL3X Tiny 3 Family see chapter 7.2 Accessory Parts.
2.3
Physical size, assembly
The FL3X Tiny 3 Family modules have following physical dimensions (length * width): 35 * 30 mm². The
height is about 10 mm.
FL3X Tiny 3 Family modules are inverse polarity protected by polarized connectors.
Created by
STAR ELECTRONICS GmbH & Co. KG
Date created
2023-01-26
Please check the manual of your carrier device which FL3X Tiny 3 is supported
before using a dedicated FL3X Tiny 3!
Use only accessories from STAR ELECTRONICS GMBH & Co. KG listed in chapter
7.2 with the FL3X Tiny 3 Family to ensure proper function and for warranty
reasons!
Other accessories without prior written consent of STAR ELECTRONICS GMBH &
Co. KG must not be used.
Date modified
NOTICE
NOTICE
2023-01-26
Page 9 of 25