Appendix; Appendix A: Guideline For Handling Esd Sensitive Products; Acronyms And Abbreviations - Star FL3X Tiny 3 Series Instructions For Use Manual

8

Appendix

8.1

Appendix A: Guideline for handling ESD sensitive Products

 Any tester, equipment, or tool used at any production step or for any manipulation of semi-
conductor devices must have its shield connected to ground.
 The product itself and the carrier system of the product respectively must be placed on a
conductive table top or covered by an antistatic surface (superficial resistivity equal to or higher
than 0.5 MΩ/cm
to ground isolated through a 1 MΩ resistor placed in series).
 All manipulation of finished goods has to be made at such a grounded worktable.
 The worktable must be free of all non-antistatic objects.
 An antistatic floor covering grounded through a conductive ground cable (with serial resistor
between 0.9 MΩ and 1.5 MΩ) should be used.
 It is recommended that you wear an antistatic wrist or ankle strap, connected to the antistatic floor
covering or to the grounded equipment.
 If no antistatic wrist or ankle strap is worn, touch the surface of the grounded worktable before
each manipulation of the ESD sensitive product.
 It is recommended that antistatic gloves or finger coats be worn.
 It is recommended that nylon clothing be avoided while performing any manipulation of parts.
8.2 Appendix B:
8.2.1

Acronyms and Abbreviations

Item
BP Bus plus
BM Bus minus
CAN Controller Area Network
EMC Electromagnetic Compatibility
ESD Electro Static Discharge
FR FlexRay
ETH Ethernet
BRR BroadR-Reach
NC Not Connected
SIC CAN Signal Improvement Capability
Created by STAR ELECTRONICS GmbH & Co. KG
Date created 2023-01-26
), grounded through a ground cable (conductive cable from protected equipment
2
Date modified
Definition
2023-01-26 Page 23 of 25