3-00881G03 Fl3X Tiny3 4*Can-Fd Sic - Star FL3X Tiny 3 Series Instructions For Use Manual

4-channel FlexTiny 3
Figure 2: Block diagram for the FL3X Tiny3 4*CAN-FD with 4 channels and bypass switch link
3.3.3

3-00881G03 FL3X Tiny3 4*CAN-FD SIC

The FL3X Tiny3 4*CAN-FD SIC are equipped with four TJA1462AT transceiver from NXP Semiconductors,
which supports CAN-HS and FD signals up to 8 Mbit/s. A dual pole termination relay per two CAN channels
(channel A and C at the same time and channel B and D at the same time) are also included, which can
terminate the buses with 120 ohms per channel, even the device is not powered. Sleep and wakeup
functionality are supported. The bypass for data (Ethernet only) switched between the Tinys is supported
by this Tiny.
Pin
Binder D-sub
1 7
2 2
3 8
4 4
5 6
6 1
7 9
8 5
3
Table 5: FL3X Tiny3 4*CAN-FD SIC connector pinouts
Created by STAR ELECTRONICS GmbH & Co. KG
Date created 2023-01-26
PHY-C
Filter
(CAN-FD)
PHY-A
Filter
(CAN-FD)
PHY-B
Filter
(CAN-FD)
PHY-D
Filter
(CAN-FD)
FL3X Tiny3 4*CAN-FD SIC connector pinouts
Signal Name
Bus_A-high CAN-FD bus high signal connection of bus A
Bus_A-low CAN-FD bus low signal connection of bus A
Bus_B-high CAN-FD bus high signal connection of bus B
Bus_B-low CAN-FD bus low signal connection of bus B
Bus_C-high CAN-FD bus high signal connection of bus C
Bus_C-low CAN-FD bus low signal connection of bus C
Bus_D-high CAN-FD bus high signal connection of bus D
Bus_D-low CAN-FD bus low signal connection of bus D
GND GND Line
previous Tiny
Switch
Up
Termi-
nation
Termi-
nation
Switch
Down
next Tiny
Description
Date modified 2023-01-26 Page 13 of 25