Sharp VL-Z100H Quick Start Manual

CAMCORDER QUICK START GUIDE
1 2
Attaching and
Removing the
Battery Pack
1
Attaching
1
Make sure that the 2
Power switch is set to
OFF.
2
Open the LCD monitor to a 90°
angle to the camcorder body.
90°
3
3
Slide the battery pack in the
direction of the arrow with the "m"
mark facing out.
"m" mark
4
Push the battery pack in the
direction of the arrow until it clicks.
Removing
Slide the battery release in the direction
of the arrow, and then take the battery
pack out.
Battery release
Web-site: www.sharp.co.uk/customersupport Help Line UK:08705 274277, Ireland:(01) 676 0648
VL-Z300H/VL-Z100H-Quick 1
All manuals and user guides at all-guides.com
3
Charging the Inserting and
Battery Pack Removing a Cassette
Inserting
Attach the battery pack to the
1
camcorder, and make sure that the
Attach the power source to the
Power switch is set to OFF.
camcorder, then slide and hold
the cassette compartment door
Connect the supplied power cord to
release as you open the cassette
the AC power socket on the AC
compartment door.
adapter, and insert the AC plug into
a power outlet. Cassette compartment door release
AC power socket
To power
outlet
2
Insert a commercially available
Insert the DC plug into the DC IN
Mini DV cassette fully with the
jack of the camcorder.
window facing outwards, and
• The POWER/CHARGE (RED)
with the erasure protect tab
indicator lights up red.
facing upwards.
POWER/CHARGE (RED)
indicator
Erasure protect tab
DC IN jack
3
DC plug
Press the "PUSH" mark gently
until the cassette holder clicks
• The POWER/CHARGE (RED)
indicator turns off when the battery
into place.
is charged.
"PUSH" mark
4
Wait for the cassette holder to
fully retract. Close the compart-
ment door by pressing the centre
until it clicks into place.
Removing
Perform step 1 above, then take out the
cassette.
Please consult the supplied operation manual for further details on these and other functions of your camcorde
4 5
Using the Lens
Cap
Attach the strap of the lens cap to the
1
hand strap as shown below.
When attaching or removing the lens
cap, grasp the indents on both sides of
the cap.
2
Indents
When recording, remove the lens cap
and attach the lens cap cord to the
fastener so that the cap will not get in
the way.
3
Fastener
04.2.12, 1:41 PM
6
Adjusting the Using the Grip
Hand Strap
Rotate the grip 135° forward or 105°
downward so that you can record
Open the hand strap flap (1) and images easily from high or low angle.
grip strap (2).
135°
Grip strap
Hand strap flap
Loosen the grip strap, pass your
right hand through the hand strap,
and put your thumb close to the
Record Start/Stop button and your
index finger on the Power Zoom
control. Then, pull the grip strap
tight until it fits snugly.
105°
Note:
• The grip cannot rotate when a tripod is
attached.
Seal the Velcro ® fasteners of the
grip strap and the hand strap flap.
TINSEA081W
04P03-M-G