Quectel AF55C Hardware Design page 58

to the OEM the labeling requirements, options and OEM user manual instructions that are required (see
next paragraph).
For a host using a certified modular with a standard fixed label, if (1) the module's FCC ID is not visible
when installed in the host, or (2) if the host is marketed so that end users do not have straightforward
commonly used methods for access to remove the module so that the FCC ID of the module is visible;
then an additional permanent label referring to the enclosed module:"Contains Transmitter Module FCC
ID: XMR202309AF55C." or "Contains FCC ID: XMR202309AF55C." must be used. The host OEM user
manual must also contain clear instructions on how end users can find and/or access the module and the
FCC ID.
The final host / module combination may also need to be evaluated against the FCC Part 15B criteria for
unintentional radiators in order to be properly authorized for operation as a Part 15 digital device.
The user's manual or instruction manual for an intentional or unintentional radiator shall caution the user
that changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment. In cases where the manual is provided only in a form other
than paper, such as on a computer disk or over the Internet, the information required by this section may
be included in the manual in that alternative form, provided the user can reasonably be expected to have
the capability to access information in that form.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment.
IC Certification Requirements.
This device contains licence-exempt transmitteris)/receivers) that comply with Innovation, Science and
EconomicDevelopment Canada's licence-exempt RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
To comply with IC regulations limiting both maximum RF output power and human exposure to RF
radiation, maximum antenna gain (including cable loss) must not exceed:
❒ Bluetooth/Bluetooth LE/Wi-Fi 2.4G:≤-0.10 dBi
❒ U-NII-1:≤ -0.9dBi
U-NII-2A:≤-1.4dBi
U-NII-2C:≤-0.3dBi
U-NII-3:≤0.4dBi
L'appareil contient un émetteur / récepteur exempté de licence conforme au CNR exempté de licence
d'innovation, sciences et développement économique Canada. Les opérations sont soumises aux deux
conditions suivantes:
AF55C_Hardware_Design
Automotive Wi-Fi&Bluetooth Module Series
57 / 58