Sony DCR-TRV8 Operating Instructions Manual page 65

Audio dubbing
Notes
* New sound cannot t_" recorded on a tape already recoMed in the 16 bit m_Kte (32 kl t
44.1 kl tz or 48 kHz) (p. 76).
• When an external microphone is not connected, the recording will be made through
the built-in microphone of your camcorder.
• New _}und cannot be recorded on a tape already recorded in the LP mode.
• You cannot add audio with the _ DV IN/OUT jack.
If you make all the connections
The attdio input to be recorded will take precedence over others in the following orde:
• M1C (PLUG IN POWER) jack
* Intelligent accessory shoe
• AUDIO/VIDEO jack
• Built-in microphone
If an i.LINK cable (DV c'onhecting cable) is connected to your camcorder
You cannot acid a sound to a recorded tape.
To add new sound more precisely
Press ZERO SET MEMORY at the point where you want to stop recording later in the
playback mode.
Carry out steps 3 to 5. Recording automatically stops at the point where ZERO SET
MEMORY was pressed.
We recommend you to add new sound on a tape recorded with your camcorder
If you add new sound on a tape recorded with another eamcorder (including
DCR-TRV8/TRV10), the sound quality may become worse.
If you disconnect or connect the i.LINK cable (DV connecting cable) to your
camcorder during recording
The recording n'tay stop.