Sony DCR-TRV8 Operating Instructions Manual page 159

"_" Hint
If a message box appears indicating a communications problem, refer to steps 6 and 7
Com_ections and Settings, and perform the following steps:
• Decrease the baud rate.
• Confirm that the port settings are correct.
Note
If an image has been read and any of the following actions taken, repeat the procedur
from step 1.
Power to the MS Serial Port Adapter has been turned off and back on.
The cable has been disconnected.
The Memory Stick was removed."
Notes
• After working with an image after viewing the List View, such as Single-Jmage
viewing, some time will be required to re-read the images.
• As the MS Serial Port Adapter and PC are busy communicating until all image are
read, do not disconnect the cable during this period.
• If an error occurs, disconnect and then reconnect the PC serial Cable at the MS Seri,
Port Adaptor side.
Please see page 25.