Figure 7-3
(1) End shields
(2) Sealing gaps
(3) Housing
Before you screw on the end shields, seal the gaps (2) with MARSTON HYLOMAR SQ32M
sealant.
Notice
Check the sealing elements fitted (e.g. at the terminal boxes) and replace them if they do not
provide an adequate seal.
Notice
Follow the application and safety instructions of the manufacturer when using the sealant.
Installing the active parts of the bearings
SIEMENS AG, 1PH718 A5E00215729A
Operating Instructions - Three-phase induction motor - AH 180
Sealing gap between enclosure and end shields
V 2.0
Maintenance
7.3 Repair
7-13