Starkey StarLink Remote Control 2.0 User Manual page 8

14 | Additional guidance
Use on Aircrafts
The Remote Control 2.0 should not be used on aircrafts unless
specifically permitted by the flight personnel.
International Use
The Remote Control 2.0 is approved to operate at radio
frequencies that are specific to your country or region and
might not be approved for use outside your country or region.
Be aware that operation during international travel may cause
interference with other electronic devices, or other electronic
devices may cause interference with your Remote Control 2.0.
Your Remote Control 2.0 is designed
95% rH 60° C
to operate within the temperature
10% rH -20° C
range of -20°C to +60°C (-4°F to
140°F), relative humidity range of 10%-95%, and altitude limits
70 kPa – 106 kPa (equivalent to altitudes from 1,200 ft (380 m)
below sea level to 10,000 ft (3,000 m).
Your Remote Control 2.0 is designed to be transported within
the temperature range of -40˚C (-40˚F) to 60˚C (140˚F), relative
humidity range of 10%-95%, and altitude limits 70 kPa – 106
kPa (equivalent to altitudes from 1,200 ft (380 m) below sea
level to 10,000 ft (3,000 m).
We are required by regulations to provide the following
warnings:
WARNING:
Use of the Remote Control 2.0 directly next
to other electronic equipment should be avoided because it
could result in improper performance. If such use is necessary,
note as to whether your hearing aids and the other equipment
are operating normally.
WARNING:
Use of accessories, components or
replacement parts other than those provided by the
manufacturer of the Remote Control 2.0 could result in
increased electromagnetic emissions and decreased
electromagnetic immunity and could result in degradation
of performance.
WARNING:
If Portable Radio Frequency communications
equipment is used closer than 30 cm (12 inches) from your
Remote Control 2.0, degradation of the performance of your
hearing aid could result. If this occurs, move away from the
communications equipment.
The Remote Control 2.0 has a rating of IP 52 per IEC 60529.
This means that the Remote Control 2.0 is protected from dust.
Do not connect the Remote Control 2.0 to any external device.
The expected service life of the Remote Control 2.0 is 3 years.
Wireless Technical Description
Starkey Laboratories, Inc. Remote Control 2.0 operates in
the 2.4 - 2.4835 GHz band with a maximum effected radiated
power of 3 dBm with transmission modulation type of
1M06F1W. The receiver section of the radio has a bandwidth
of 2 MHz.
The Remote Control 2.0 has been tested to, and has passed,
the following emissions and immunity tests:
• IEC 60601-1-2 radiated and conducted emissions
requirementsfor a Group 1 Class B device as stated in
CISPR 11.
• RF radiated immunity at a field level of 10 V/m between
80 MHz and 2.7 GHz as well as higher field levels from
communications devices as stated in Table 9 of IEC
60601-1-2.
• Immunity to power frequency magnetic fields at a field
level of 30 A/m and to proximity magnetic fields as stated
in Table 11 of IEC 60601-1-2.
• Immunity to ESD levels of +/- 8 kV conducted
dischargeand +/- 15 kV air discharge.
EU ADVERSE EVENT REPORTING
Any serious incident that has occurred in relation to your
device should be reported to your local Starkey representative
and the Competent Authority of the Member State in which
Additional guidance | 15