Information Codes - Samsung WF231 Series User Manual

tFoubeshoot ng and
INFORMATION CODES
Information codes may be displayed to help you better understand what is occurring with your Washer.
Unbalanced load prevented your
Washer from spinning.
Door is open when Washer is
running.
Your Washer failed to lock the
door.
Redistribute the load, press the Start/Pause
Button.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
HZ Water temperature contro,
} I ¸¸¸¸ roblem
Heater Control problem)
Your Washer has tried to fill but
has not reached the proper water
level.
I I"1 The door will not unlock.
I._l..J
Call for service.
Call for service.
Make sure the door is firmly closed.
Push the Power button to turn off your Washer,
Motor not running properly.
Your washer is not draining.
It can also mean that the unit
senses a small clog while draining.
Your Washer has tried to fill but
was unsuccessful.
Check if the hot water supply
hose is connected.
The hot/co,d water hose
connection is not correct.
PF Electric service was lost when
Washer was running.
then turn it on again. If the code reappears, call
for service.
Restart the cycle pressing the Start/Pause
Button. If the code reappears, call for service.
First of all, clean up the drain filter. Then
check the following.
1) Turn off the unit and turn it on again.
2) Select only the Spin Cycle.
3) Press the Start/Pause to drain the water.
Clean the debris filter.
If it still does not drain, call for service.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
If you use a Flood Sdety Device, then please
remove the device and connect the water hoses
directly to the unit.
You must connect the hot water supply hose
because hot water is supplied by the Auto
Temperature Control (A.T.C.) function if the
temperature of the cold water is lower than 59°R
Please connect the hot/cold water hose
connection correctly.
Restart the cycle by pressing the Start/Pause
Button.
30 troubleshooting and information codes
WF231ANW-02832D EN.indd Secl0:30 2011-04-18 10:38:30 I