Installing Your Washer - Samsung WF231 Series User Manual

ettinG voLJr w asher
L_J I J
INSTALLING YOUR WASHER
STEP 1
Selecting a location
Before you install the washer, make sure the location:
Has a hard, level surface without carpeting or flooring that may obstruct ventilation.
Has no dust, oil and detergent etc.
Is away from direct sunlight.
Has adequate ventilation.
Will not be freezing (below 32 °F or 0 °C).
Is away from heat sources such as oil or gas.
Has enough space so that the washer doesn't stand on its power cord.
STEP 2
Removing the Shipping Bolts
Before using your Washer, you must remove the four
shipping bolts from the back of the unit.
t. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with
the spacer through the hole in the rear wall of your
washer. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
STEP 3
Installing your Washer
t. Place the drain hose in the drain facility (tub,
sink, or standpipe.) If you connect the drain
hose to a standpipe, be sure an airtight
connection is NOT made between the drain
hose and the standpipe. The standpipe
must be at least 18 inches or 46 cm high
and no higher than 96 inches.
Caution must always be exercised to
avoid collapsing or damaging the drain
hose. For best results, the drain hose
should not be restricted in any way - by
elbows, couplings, or excessive lengths.
For situations where the drain hose
cannot be conveniently elevated to at
least 18 in or 46 cm, the drain hose must
be supported.
Laundry tub
ose
r_alner
_,, Ma×
18"MIn
TI tp
Stand pipe
16 settin 9 up your washer
WF231ANW-02832D lgN.ii:,dd Sec5:16 2011-04-18 10:38:12 I