Installing Your Washer - Samsung WA85GWG User Manual

This model is part of a product safety recall. for more information, please visit samsung.com/au/washingmachinerecall/

Table of Contents

setting up your washer

INSTALLING YOUR WASHER

Step 1

Selecting a location

Before you install your washer, make sure the location:

•

Has a hard, level surface without carpeting or ﬂ ooring that may obstruct ventilation and avoid

vibrations

•

Allows at least 4 in (10 cm) between the washer and the wall

•

Is away from direct sunlight and not exposed to rain as moisture may destroy the electrical

insulation causing an electrical shock hazard

•

Has adequate ventilation

•

Is not exposed to temperatures below freezing (below 32 ˚F and 0 ˚C)

•

Is away from heat sources such as oil and gas

•

Has enough space so that your washer doesn't stand on its power cable

Step 2

Connecting the water supply hose to the washer

Connect the other end of the water supply hose to the

inlet water valve at the back of the washer. Screw the hose

clockwise all the way in.

1. Remove the adaptor from the water supply hose.

2. First, using a "+" type screw driver, loosen the four screws

on the adaptor. Next, take the adaptor and turn part(b)

following the arrow for gap about 5 mm between them.

18_ setting up your washer

WA85GWWIP-03222A-03_EN.indd Sec3:18

2013-01-29

2:42:37

Table of Contents

Wa85gww