Mounting Bracket; Base Station Installation - Yaesu FT-480R Instruction Manual

STAND
Figure |
Connect the RED lead of the power cord to the
POSITIVE (+) battery terminal, and connect the
BLACK lead to the NEGATIVE (—) terminal. If it
is necessary to extend the power cable, use #16
AWG insulated copper wire, and use the minimum
length practicable to reduce voltage drop.
WARNING
NEVER APPLY AC POWER TO THE REAR
PANEL POWER JACK OF THE TRANS-
CEIVER. NEVER CONNECT A DC POWER
SOURCE OF GREATER THAN 15 VOLTS
TO THE REAR PANEL POWER JACK.
ALWAYS REPLACE FUSES WITH A FUSE
OF THE PROPER RATING. FAILURE TO
OBSERVE THESE SIMPLE PRECAUTIONS
WILL VOID ALL WARRANTIES ON THIS
EQUIPMENT.
CC
DASHBOARD
". MOUNTING
€5 BRACKET
GUIDE RAIL
Connect the power cable to the POWER receptacle
on the rear apron, connect the coaxial cable from
the antenna to the rear apron ANT receptacle, and
connect the microphone to the jack appropriate
for the microphone in use. An external speaker
may be connected to the rear apron SP jack, if
desired. Use the speaker plug supplied with the
transceiver. Insertion of a plug into this jack auto-
matically cuts off the internal speaker.
BASE STATION INSTALLATION
A base station mounting stand is supplied with
your transceiver, to provide easier viewing of the
display and controls. A power supply capable of
supplying 5 amps at 13.8 VDC is required for
operation from AC mains. The FP-80A AC power
supply option provides the required 13.8 VDC for
the FT-480R transceiver. See your Yaesu dealer.
a epee -)1-Tenie
aq [OO 0or12 ZSO880y) 0103
.
3.3K
ee
NOTE
J ALL RESISTORS GRE IN v4W UNLESS
OTHE WISE NOTED.
2ALL CAPACITORS ARE yk