Preparation Before Use - Hisense CBBT241AG Use And Installation Instructions

Table of Contents

Advertisement

Preparation before use

Note
When charging refrigerant into the system, make sure to charge in liquid state, if the
refrigerant of the appliance is R410A.Otherwise, chemical composition of
refrigerant (R410A) inside the system may change and thus affect the performance
of the air conditioner.
According to the character of
pressure of the tube is very high, so be careful when you install and repair the
appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
The air conditioner must be installed by a professional engineer.
The temperature of refrigerant circuit will be high, please keep the
interconnection cable away from the copper tube.
Before using the air conditioner, be sure to check and preset as the following.
Remote Controller presetting
Each time after the remote control is replaced with new batteries or is energized, remote control auto
presetting heat pump.If the air conditioner you purchased is a Cooling Only one, heat pump remote
controller can also be used .
Back-light function (optional)
Hold down any button of the remote controller for about 2 seconds, the back-light will be turned on.
It will be turned off automatically after about 10 seconds.
Note: Back-light is an optional function.
Auto Restart Presetting
The air conditioner has Auto-Restart function.
You can set or cancel this function when the air conditioner is running.
Hold down the emergency button(ON/OFF) for a few seconds, this function will be set if you hear
beep twice. If you just hear beep once, this function will be canceled.
Safeguarding the environment
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal,recycle it
responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
refrigerant (R410A,the value of GWP is 1975), the
2

Advertisement

Table of Contents
loading

Table of Contents