Table of Contents
Advertisement
www.ti.com
7
WinVCC Quick Start
Perform the following steps to get an MPEG-2 transport stream out of the TVP9900EVM.
1. Once WinVCC is executed, the WinVCC Configuration screen appears, as shown in
dialog box configures the I
is set to 0xB8 (default setting on EVM.) This must match the I
2
2. The tuner I
C address is set by default in WinVCC to 0xC2. This is also the default setting on the tuner
EVM board; verify the correct TUNER_AS jumper setting on the tuner board.
Note:
If WinVCC is running and the TVP9900 or tuner board I
must be cycled on the EVM.
3. Ensure that all other boxes are set to NOT USED and that all program options buttons are set to
ENABLE. Click OK.
4. If there are no I
shown in
Figure
WinVCC, double check the parallel port cable connections, cycle power on the TVP9900EVM, and run
WinVCC again.
SLEU081A – March 2007 – Revised July 2007
Submit Documentation Feedback
2
C bus. Next to TVP9900, select the TVP9900 and ensure the I
Figure 3. WinVCC – I
2
C communication issues, the WinVCC Main Screen dialog window displays next, as
2
4. If there are I
C issues, an I
Figure 4. WinVCC – Main Screen
2
C ADDR jumper on the TVP9900 board.
2
C address is changed, power
2
C Configuration Screen
2
C Test Report box displays. Completely exit out of
WinVCC Quick Start
Figure
3. This
2
C address
TVP9900EVM User's Guide
11
Advertisement
Table of Contents
