Skil PR0601B-00 Owner's Manual page 26

c. Place the chain-drive links into the guide-bar
groove. Position the chain so there is a loop
at the back of the guide bar (Fig. 18d).
d. Place the loop around the sprocket.
When looping the saw chain onto
NOTICE
the sprocket, make sure that the
direction of the saw chain cutters match the
cutter pattern and rotation direction arrow on
the housing. If they face in opposite directions,
turn over the saw chain and guide bar
assembly.
e. Lift the kickback guard. Place the guide bar
on the mounting surface by sliding the guide-
bar slot over the screw (Fig. 18e).
f. Replace the side cover and lightly tighten the
side-cover knob by turning it clockwise, but
do not fully tighten it (Fig. 18f).
To extend the guide bar life,
NOTICE
invert the bar occasionally.
CAUTION
using.
26
The saw chain must be
properly tensioned before
Fig . 18d
Bar groove
Fig . 18e
Screw
Tension Pin
Fig . 18f
Chain-drive links
Rotation Direction Arrow
Cutter Pattern
Sprocket